Connection Of The Electric Cable To Electricity - Lotus BR 50-78 ET Instrucciones Para La Instalación

No subjects from combustible materials can be placed directly on the device or in distance which is shorter
than safety distance (the shortest allowed distance is 10 cm).
See Tab: combustion degree of building materials classified according to the combustion degree of
materials and product Act No. (EN 730823)
A – non combustible
B – uneasily combustible
C1 – hardly combustible
C2 – middle combustible
C3 – easily combustible
Appliances must be installed in a safe way. When installing you must respect corresponding project, safety
and hygienic orders according to:
•Act No. EN 06 1008 fire protection of local device and sources of heat
•Act No. EN 33 2000 environment for electric devices
Before you start, make sure that the voltage and capacity of the power line conform to the data shown on the
identification plate located on the side of the device. The appliance must be connected to earth in
compliance with electrical system safety regulations.
Power supply cable installation – this power supply cable must be fitted with Omni polar circuit breaker
corresponding to power of installed device.
To access terminal board placed on the back side of the device, whole back panel needs to be
disassembled.
If a fixed connection is being used, fit the power line with an Omni polar circuit breaker with a contact
opening gap equal to or greater than 3 mm, in an easily accessible position close to the appliance. Ground
cable (yellow-green colour) shall not be interrupted with this breaker.
If a plug and socket connection is being used make sure that the plug and socket are compatible. Avoid use
of adapters and shunts as these could cause overheating and burns.
In the case of linear connection of several devices the device must be grounded in each other point for that
purpose, which is located on the back of device.
In any case, the cable must be positioned so that at no point temperature will not reach 50° of Celsius
degrees higher than the common surrounding.
After connecting the device to the electricity, the entire installation and operation of the device must be
tested
Before first use all protection foils must be removed.
Manufacturer reserves the right refuse any responsibility in case of damages caused by wrong
installation, by disobeying of above mentioned recommendations
Granite, sandstone, concretes, bricks, ceramic, wall facing tiles
acumen, Heraclites, lihnos, itavere
Leafy wood, plywood, sirkoklit, rare paper, Formica
fibreboards, solodure, cork boards, rubber, floor- coverings
Wood-fibreboards, polystyrene, polyurethane, PVC

Connection of the electric cable to electricity

8