Vortice VORT-ICE GO 12K Manual De Instrucciones página 31

ENGLISH
Adjust the air vent
Before using the unit, please open the horizontal louver.
Fig. 17
Auto Mode
The unit will begin working in one of two modes:
•
If the room temperature is higher than 24°C
24°C the unit will work in fan mode.
• At this time, the indicator lights on the control panel will display the current mode.
• Please note in this mode the unit will work around a fixed temperature of 24°C. If the user requires a different
temperature, please set the unit to cooling mode.
Note: The digital display shows the ambient room temperature from 0°C to 50°C.
Setting mode/function
Press the MODE button to switch modes between: Auto, cooling, fan or dehumidify (dry).
The corresponding LED of your selected mode comes on.
Setting temperature
1. Press 'Temperature up' or 'Temperature down' button to set the desired temperature.
2. The display will show the temperature you set as you press 'Temperature up' or 'Temperature down'. Otherwise, it will
always show the ambient temperature.
3. The pre-set temperature of the Ice Go is 24°C for cooling.
Setting ventilation speed
Press SPEED button to choose the ventilation speed between high, medium and low. The control panel will light up the
corresponding speed's LED.
Setting timer
1. Press TIMER button to set the operating time (1 to 24 hours, the timer LED will turn on). When the set time has been
reached, the machine will turn off automatically. The display window will show the hour(s) you set as you press the
TIMER button. If the button is not pressed, the unit will work continuously.
2. By pressing the timer button while the unit is off you can set the unit to turn on after a pre-set amount of time. For
example, if you set the timer to '2', the unit will automatically turn off after 2 hours.
Adjust the horizontal and vertical louvers to your desired direction.
the unit will work in cooling mode. If the room temperature is below
Fig. 16
31