Maintenance; Troubleshooting - Vortice VORT-ICE GO 12K Manual De Instrucciones

ENGLISH

Maintenance

Always unplug the air conditioner from the mains before cleaning.
To maximize the efficiency of the air conditioner, clean the unit regularly.
Cleaning the housing
Use a soft, damp cloth to wipe the body clean.
Never use aggressive chemicals, gasoline, detergents, chemically treated cloths, or other cleansing solutions.
Cleaning the filter
Use a vacuum cleaner or tap the filter lightly to remove loose dust and dirt from the filters and then rinse
thoroughly under running water (no hotter than 40°C).
Dry thoroughly before replacing.
Please Note: Never operate the unit without the filters.
End of season storage
Drain any water from the unit and leave it on ventilation only mode for a
•
few hours, to thoroughly dry the inside.
• Clean the filter
• Unplug and store the power cord as shown
• Replace in the original carton or cover for storage.

Troubleshooting

The air conditioner does not run:
Too noisy:
The compressor doesn't run:
Never try to repair or dismantle the unit yourself
The Vort-Ice Go series should be connected only to a power supply with the relevant system impedance no more than
0.309 ohm. Restrictions to connection may be imposed by the supply authority on the use of equipment in the actual
relevant system impedance at the interface point on the user's premise exceeds 0.309 ohm.
34
• Is the air conditioner plugged in?
• Is there a power failure?
• Is the 'tank full' indicator flashing?
• Is the room temperature below the set temperature?
• Is the machine positioned unevenly so as to create vibration ?
• Is the floor underneath the machine uneven?
• It is possible the overheat protection of the compressor is on.
Turn off the Vort-Ice Go and let it rest for 30 minutes and turn it
back on.
Power cord
inside
Fig. 24