Safety Precautions; Identify And Locate Components - Lincoln Electric Pro-MIG 140 Manual Del Operador

A-2
Read entire installation section before starting
installation.

SAFETY PRECAUTIONS

WARNING
ELECTRIC SHOCK can kill.
• Only qualified personnel should perform
this installation.
• Only personnel that have read and under-
stood the Pro-MIG 140 Operating Manual
should install and operate this equipment.
• Machine must be plugged into a receptacle
which is grounded per any national, local
or other applicable electrical codes.
• The Pro-MIG 140 power switch is to be in
the OFF ("O") position when installing
work cable and gun and when connecting
power cord to input power.
IDENTIFY AND LOCATE
COMPONENTS
If you have not already done so, unpack the Pro-MIG
140 from its carton and remove all packing material
around the Pro-MIG 140. Remove the following loose
items from the carton (see Figure A.1):
1. Pro-MIG 140
2. Gun and cable assembly
3. Literature and miscellaneous including:
a) This operating manual
b) 3 extra .023"-.025" (0.6 mm) contact tips
c) 2 extra .035" (0.9 mm) contact tips
d) Hex key wrench for removal of drive roll.
4. 10 ft (3.0 m) work cable.
5. Work clamp.
6. a) 2lb. spool of .025" (0.6 mm) Super Arc L-56
MIG wire.
b) Sample spool of Innershield .035" (0.9 mm)
NR-211-MP.
7. Welding Helmet.
8. Adjustable mixed-Gas Regulator & Hose.
9. Instructional video.
10. Nozzle.
For available options and accessories refer to the
Accessories Section of this manual.
1) As shipped from the factory, the Pro-MIG 140 gun
liner is ready to feed .023" (0.6 mm) -.035 (0.9 mm)
wire.
INSTALLATION
(1)
Pro-MIG 140
FIGURE A.1
1
3
5
7
9
A-2
2
4
6
8
10