Safety Devices On The Product - Husqvarna 545RXT AutoTune Manual Del Usuario

• Use protective boots with steel toe-cap and non-slip
soles.
• Use clothing made of a strong fabric. Always use
heavy, long pants and long sleeves. Do not use
loose clothing that can catch on twigs and branches.
Do not use jewelry, short pants or sandals. Do not
go with bare feet. Put your hair up safely above
shoulder level.
• Keep first aid equipment near.

Safety devices on the product

For information about where to find the safety devices,
Product overview on page 2 .
see
WARNING: Read the warning instructions
that follow before you use the product.
• Do not use a product with defective safety devices.
Do a check of and do maintenance on the safety
devices regularly. If the safety devices are defective,
speak to your Husqvarna service agent.
• Do not make changes to safety devices. Do not use
the product if protective covers, safety switches or
other protective devices are not attached or are
defective.
• For all service and repair work on the product,
especially for the safety devices, special training is
necessary. If the safety devices fail the checks given
in this operator's manual, you must let a service
agent help you. We guarantee that professional
repairs and service is available. If your dealer is not
a service agent, speak to them for information about
the nearest service agent.
• Do not use a cutting attachment without an approved
and correctly attached cutting attachment guard. See
To assemble the cutting equipment on page 11 .
To do a check of the throttle trigger lockout
The throttle trigger lockout locks the throttle trigger at the
idle position.
171 - 008 - 08.06.2020
1. Press the throttle trigger (B) and make sure that it is
locked.
2. Press the throttle trigger lockout (A). Make sure that
the throttle trigger (B) is released.
B
3. Release the handle and make sure that the throttle
trigger lockout (A) and the throttle trigger (B) go back
to their initial positions.
4. Press the throttle trigger lockout (A) and make sure
that it goes back to its initial position when you
release it.
5. Press the throttle trigger (B) and make sure that it
goes back to its initial position when you release it.
6. Start the engine and apply full throttle.
7. Release the throttle trigger and make sure that the
cutting attachment stops.
A
A
B
7