Adjusting The Airflow Direction For Multiple Indoor Units Using A Single Remote Control Unit - Airwell ST-NKFL 7R Manual De Instrucciones

01_Airwell_ST-NKFL7R_GB.fm Page 10 Thursday, July 2, 2009 4:01 PM
Auto Flap ( ) button
One outdoor unit and eight indoor units
No display
Two outdoor units and four indoor units
Unit No.
No display
1–1
10
Adjusting the Airflow Direction for
Multiple Indoor Units Using a Single
Remote Control Unit
• The airflow direction cannot be set using the remote control unit for
concealed duct type (NDHP, NDLP, DAV), and floor standing type (NFFL,
NFMFL).
• If multiple indoor units are connected to a remote control unit, the airflow
direction can be set for each indoor unit by selecting the indoor units (see
the operation below).
• To set the airflow for individual units, press the UNIT button. Display shows
the indoor unit number under group control. Set the airflow direction for the
indoor unit that is shown on the display.
• Each time UNIT is pressed, the indicator changes in the order shown
below.
• When nothing is displayed, you can make the setting for all indoor units in
one operation.
• The unit number is displayed as Outdoor Unit Number–Indoor Unit
Number. It varies depending on the number of units under group control.
Unit No. Unit No.
1–2
1–1
Unit No. Unit No.
1–2 1–3
Unit No.
1–3
Unit No. Unit No.
1–4 2–1
Unit No.
1–8
Unit No.
2–4
OI-824-10-GB