Sony UP-20 Manual De Instrucciones página 64

When IMMED. CAP. is set to OFF:
Remote control
pulse signal
Notation Parameter
tRPE Time within
which a remote
control pulse
should be cleared
to zero.
tRPW Length of a
remote control
pulse
VRP Amplitude of a
remote control
pulse
The above example shows that the images at the seventh
and eighth positions are captured. However, images at
other positions could be captured depending on the
printer mode and printer settings.
Note
When AUTO LIVE of the FUNCTION SETUP menu is
set to OFF, the memory image is displayed on the screen
after the image is captured in memory. In such a case,
whenever you capture an image, press the SOURCE/
MEMORY button so that the source image appears on
the video monitor. Displaying the memory image does
not allow you to capture the image with the correct
timing.
64
Specifications
Captured image
MIN TYP MAX Unit Remarks
3 - 12 msec -
100 - - msec -
- - 5 V This value is
based on the
TTL standard.
When IMMED. CAP. is set to ON:
Captured image
Remote control
pulse signal
Notation Parameter MIN TYP MAX Unit Remarks
tRPE Time within 3
which a remote
control pulse
should be cleared
to zero.
tRPW Length of a 100
remote control
pulse
VRP Amplitude of a -
remote control
pulse
Note
This mode is effective only when the source image is
displayed on the monitor screen. If the memory image is
displayed, the image will not be captured even if the
pulse is sent to the printer. Be sure to display the source
image when sending the pulse.
Design and specifications are subject to change without
notice.
- 10 msec -
- - msec -
- 5 V This value is
based on the
TTL standard.