Connecting Wires To Terminals - Kenwood DPX503 Manual De Instrucciones

Connecting Wires to Terminals

Steering remote control
(Light Blue/Yellow)
REMO.CONT
Fuse
(10A)
Wiring harness
(Accessory1)
White
White/Black
Gray
Gray/Black
Green
Green/Black
Purple
Purple/Black
Power control wire (Blue/White)
Motor antenna control wire (Blue)
TEL mute wire (Brown)
Dimmer control wire (Orange / White)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
32
|
DPX503/DPX303
To use the steering wheel remote control
feature, you need an exclusive remote
adapter (not supplied) matches your car is
required.
To Kenwood disc changer/ External optional accessory
⁄
To connect these leads, refer to the relevant instruction manuals.
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
If no connections are made, do not let the wire come out from the tab.
When using the optional power amplifier, connect to its power control
terminal.
P.CONT
Depending on what antenna you are using, connect either to the control
ANT.
terminal of the motor antenna, or to the power terminal for the booster
CONT
amplifier of the film-type or short pole type antenna.
Connect to the terminal that is grounded when either the telephone rings
or during conversation.
MUTE
⁄
To connect the Kenwood navigation system, consult your navigation
manual.
To car light control switch
ILLUMI
Car fuse box
Ignition key switch
ACC
FM/AM antenna input
Front preout
Rear/SubWoofer preout
Car fuse box
(Main fuse)
Battery