Getting Started; Supplied Accessories; Putting The Batteries Into The Remote Control; Connecting Antennas - JVC UX-J60 Manual De Instrucciones

Getting Started

Supplied Accessories

Make sure that you have all the following items.
The number in parentheses indicates the quantity of each
piece supplied.
• AM loop antenna (1)
• FM antenna (1)
• Remote control (1)
• Batteries (2)
• Speaker cords (ONLY FOR UX-J60) (4)
• AC plug adapter—except for Argentina (1)
If anything is missing, consult your dealer immediately.

Putting the Batteries into the Remote Control

Insert the batteries—R6(SUM-3)/AA(15F)—into the
remote control, by matching the polarity (+ and –) on the
batteries with the + and – markings on the battery
compartment.
When the remote control can no longer operate the unit,
replace both batteries at the same time.
1
2
3
• DO NOT use an old battery together with a new
one.
• DO NOT use different types of batteries together.
• DO NOT expose batteries to heat or flame.
• DO NOT leave the batteries in the battery
compartment when you are not going to use the
remote control for an extended period of time.
Otherwise, the remote control will be damaged
from battery leakage.

Connecting Antennas

FM antenna
1
2
3
The FM antenna supplied with this unit can be used as temporary
measure. If reception is poor, you can connect an outdoor FM
antenna.
To connect an outdoor FM antenna
R6(SUM-3)/AA(15F)
Before connecting the antenna, disconnect the supplied FM
antenna.
FM antenna (supplied)
Attach the FM antenna to the FM 75 Ω
COAXIAL terminal.
Extend the FM antenna.
Fasten it up in the position which gives you
the best reception, then fix it on the wall,
etc.
About the supplied FM antenna
Outdoor FM antenna
(not supplied)
Coaxial cable (not supplied)
A 75 Ω antenna with coaxial type connector
(IEC or DIN 45325) should be used.
Continued
6