Testing Your Angelcare; Warnings; Care Of Your Angelcare; Monitor - Angelcare AC 420 Manual Del Propietário

ICON
NURSERY UNIT
N

Testing Your Angelcare

Note: Test your Angelcare
and then periodically.
Step 1. Have someone else speak into the nursery unit or place
a radio near nursery unit. You should hear sound from the parents
unit. If there is no sound, refer to the Troubleshooting section.
If reception is not clear, switch to another channel (see
channel key in the Icon section).
Step 2. Verify that the battery mode is functional by operating the
nursery unit without the AC adaptors. The green Power light should
appear on the Nursery unit and the digital screen should light up on
the parents unit.
Parents unit: When the Low Battery indicator icon is almost
clear, place the unit on the charger.
Nursery unit: When the green Low Battery indicator light flashes
replace batteries promptly. On the parents unit screen, the low
battery icon will flash and the nursery icon will appear.

Warnings

• This product is NOT a substitute for direct supervision of your
baby. Check your baby's activities at regular intervals.
Monitoring of premature babies, or those considered to be at
risk, should be carried out only under the supervision of a
doctor or health professional.
MEANING
Power switch on the left wing.
Power ON (green light)
and Low-battery indicator
(Flashing green light)
Night light button and channel
selector
In range selector on the right
wing
Microphone sensitivity dial
(Back of the Unit)
®

Monitor

® Monitor BEFORE first-time use
FUNCTION AND USE
Power ON = -
Power OFF = o
1) When the power is ON and the left wing button at the "-" position, the
green light will appear.
2) If the back-up batteries are low, the green light will flash.
Note :The green light will flash for 45 minutes before unit shuts itself OFF.
1) Press ON/OFF for night light.
2) Push to change channel when the parents unit is on Channel Selection
Mode. (See the Channel Key section.).
Slide switch Up to be notified when the nursery unit signal does not
reach the parents unit. (See the "In Range" icon section.).
Increases and decreases the voice activation sensitivity.
Your Angelcare® monitor is equipped with a voice-activated system. The
nursery unit will be activated and transmit sounds to the parents unit only when
it captures sounds. The sensitivity dial allows controlling the level of sound
picked up and transmitted by the nursery unit.
Note: If the microphone sensitivity level on the nursery unit is set to maximum
(completely to the right), the unit will revert to continuous sound reception
instead of voice activated mode.
• STRANGULATION HAZARD. Keep the adapter cord out of the
reach of children. Because of the serious strangulation risk to
infants and toddlers, parents and caregivers should never
place the nursery unit within 3 feet (1 metre) of a crib.
• Make sure you DON'T put the parents unit near wireless
devices and microwave ovens. This may disrupt the
transmission.
• ALWAYS place both units on a flat surface in an upright
position, away from baby's reach.
• Make sure to plug the adapter to the socket outlet nearest to
the equipment and that is easily accessible.
• DO NOT touch the end of the adapter cord when plugged into
an electrical outlet.
• The Angelcare
signals. The parents unit may pick up signals or interference
from other nursery monitors in your area. Your monitor may
even be picked up by other households. To protect your privacy,
make sure both units are turned OFF when not in use.
• This product should be serviced by qualified personnel. There
are no user serviceable parts inside the monitor. Refer all
service questions to your distributor.
Care of you Angelcare
RETAIN INSTRUCTIONS: Keep the user's manual for future
reference.
6
6
® Monitor uses public airwaves to transmit
® Monitor