Oven Lights - GE Monogram ZET1R Manual Del Propietário

Each oven is equipped with two halogen light

Oven lights

assemblies located on the side walls of the oven.
The lights come on when the door is opened or
when the oven is in a cooking cycle. The oven
lights do not come on during self-cleaning or
if the Sabbath Feature is set.
Each light assembly consists of a removable light
cover with two locking clips, a light compartment
with three light bulb sockets and three halogen
light bulbs.
CAUTION: Before replacing the bulb, disconnect
electrical power to the oven at the main fuse or
circuit breaker panel.
Be sure to let the light cover and bulb cool
completely.
For your safety, do not touch a hot bulb with bare
hands or a damp cloth.
To remove:
Remove the racks from the oven. See the Full
extension oven racks section.
Using an adjustable wrench, remove the four
nuts holding the rack support over the light
assembly.
Remove the glass light cover by pulling its back
edge out and rolling it toward you.
Do not remove any screws.
NOTE: The two locking clips may fall from the
glass light cover. Upon replacement, they will
need to be placed in the correct position on
the light cover and pressed back into the light
compartment until seated.
Using gloves or a dry cloth, remove
the burned-out light bulb by pulling
it straight out.
Care and Cleaning
Wall Oven
To replace:
Use a new 120-volt Halogen bulb, with G8 pins,
not to exceed 25 watts.
Replacement bulbs may be purchased by calling
800.626.2002. Order Part Number WB25T10064.
NOTE: Higher wattage bulbs will damage your oven.
Using gloves or a dry cloth, remove the bulb
from its packaging. Do not touch the bulb with
bare fingers. Oil from bare fingers may cause hot
spots on the glass surface and lead to premature
failure of the bulb. If you do touch the glass, clean
it with alcohol prior to installation.
Push the bulb straight into the receptacle all
the way.
Replace the light cover, by placing its
front edge under the front two tabs in the light
compartment. Roll the back edge into place,
making sure that it is firmly seated.
NOTE: If
the locking
clips fell
from the
lens cover
glass lens cover,
back edge
hold them on the
cover, in the correct
position, while
replacing the cover on
the light compartment.
The light cover must be in place when using
the oven.
For improved lighting inside the oven,
clean the glass cover frequently using a wet
cloth. This should be done when the oven is
off, disconnected from the power supply, and
completely cool.
Replace the rack support with the slotted holes
over the rear bolts and the round holes over
the front bolts. Lightly secure with the four
nuts removed earlier, but do not over-tighten
or the enamel could be chipped.
Slotted
holes
over
rear
bolts
Replace the racks. See the Full extension oven
racks section.
Reconnect electrical power to the oven.
Place front
Hold
edge of
locking
lens cover
clips in
under
place on
front two
tabs
Press the light cover
into place
Round
holes
over
front
bolts
45