Remote Management; Parental Control - Multilaser RE027 Manual Del Usuario

Click the Save button to save the settings.
Note:
If your PC is blocked but you want to access the Router again, use a pin to press and hold the Reset Button (hole) on the
back panel for about 5 seconds to reset the Router's factory defaults on the Router's Web-Based Utility.
4.9.4. Remote Management
Choose menu "Security > Remote Management", you can configure the Remote Management function in the screen as shown in
Figure 4 42. This feature allows you to manage your Router from a remote location via the Internet.
168
• Web Management Port - Web browser access normally uses the standard HTTP service port 80. This Router's default
remote management web port number is 80. For greater security, you can change the remote management web port to
a custom port by entering that number in the box provided. Choose a number between 1 and 65534 but do not use the
number of any common service port.
• REMOTE MANAGEMENT IP ADDRESS - THIS IS THE CURRENT ADDRESS YOU WILL USE WHEN ACCESSING YOUR ROUTER
FROM THE INTERNET. THIS FUNCTION IS DISABLED WHEN THE IP ADDRESS IS SET TO THE DEFAULT VALUE OF 0.0.0.0. TO
ENABLE THIS FUNCTION CHANGE 0.0.0.0 TO A VALID IP ADDRESS. IF SET TO 255.255.255.255, THEN ALL THE HOSTS CAN
ACCESS THE ROUTER FROM INTERNET.
Notes:
1)
Location (in Navigator) box, followed by a colon and the custom port number. For example, if your Router's WAN address is
202.96.12.8, and the port number used is 8080, please enter http://202.96.12.8:8080 in your browser. Later, you may be asked
for the Router's password. After successfully entering the username and password, you will be able to access the Router's web-
based utility.
2)
4.10. Parental Control
To access the Router, you should type your Router's WAN IP address into your browser's address (in IE) or
Be sure to change the Router's default password to a very secure password
Figure 4-42 Remote Management
www.multilaser.com.br