Satelite Navigation; Easy Setup Screen Settings - Snooper 6 SERIES Manual Del Usuario

1.Starting Up
Once you have synchronised the Micro-SD Card and
performed a download as necessary it is time to perform
the first Start Up. First make sure your vehicle is parked in
as open a space as possible, clear of tall trees and buildings
so that the built in GPS antenna has a clear view of the sky
above. Next switch ON the unit by pressing and holding the
standby power switch on the top left hand side of the unit for
2 seconds.
The following warning will be displayed.
Please read the warning and select the relevant vehicle type (where applicable).
Press "I Agree" to continue.
Whilst 6 SERIES software is loading a start-up display will be shown for just a few seconds and then the screen will show a section of
a map. 6 SERIES needs to acquire a minimum of four satellites in order to work. Once this has been achieved 6 SERIES will ascertain
your position and this will be indicated by a green arrow icon on the on-screen map and the GPS signal strength will be shown in the
bottom right hand corner of the display. 6 SERIES is now ready to navigate.
As the GPS engine and antenna have never been used before, the first 'Cold' start can take anywhere from 15 – 30 minutes to
establish a satellite connection. Once initialised, subsequent start ups will take less time and eventually should take only a matter
of minutes.
2. Easy Set Up
2.1 Screen settings
There are a number of map views or different types of information that can be displayed on the screen at any one time:-
3D
Screen views
Return to contents
Satellite Navigation
1
3
2 4
2D
6
7
5
15 • EN
North
11
10
9
8