After Use - Makita XSL02 Manual De Instrucciones

Ocultar thumbs Ver también para XSL02:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Bevel angle
0° bevel angle
1. Lever
2. Arm holder
adjusting bolt 4. Arm 5. Release button
1.
Push the carriage toward the guide fence and
tighten two clamp screws to secure the carriage.
2.
Lower the handle fully and lock it in the lowered
position by pushing in the stopper pin.
3.
Loosen the lever at the rear of the tool.
4.
Turn the 0° bevel angle adjusting bolt (lower bolt)
on the right side of the arm two or three revolutions
counterclockwise to tilt the blade to the right.
5.
Turn the 0° bevel angle adjusting bolt clockwise
carefully until the side of the blade makes a perpendic-
ular angle with the top surface of the turn base. Use the
triangular rule, try-square, etc. as a guide. Then tighten
the lever securely.
1
1. Triangular rule
2. Saw blade
turn table
6.
Make sure that the pointer on the arm indicates 0°
on the bevel scale. If it does not indicate 0°, loosen the
screw which secures the pointer and adjust the pointer
so that it indicates 0°.
1
5
4
3
2
3. 0° degree bevel angle
2
3
3. Top surface of
1
2
1. Bevel scale
2. Pointer
45° bevel angle
1. Left 45° bevel angle adjusting bolt
Adjust the 45° bevel angle only after performing 0°
bevel angle adjustment.
1.
Loosen the lever and tilt the blade to the left fully.
2.
Make sure that the pointer on the arm indicates
45° on the bevel scale. If the pointer does not indicate
45°, turn the 45° bevel angle adjusting bolt (upper bolt)
on the right side of the arm until the pointer indicates
45°.

After use

After use, wipe off chips and dust adhering to the tool
with a cloth or the like. Keep the blade guard clean
according to the directions in the previously covered
section titled "Blade guard". Lubricate the sliding por-
tions with machine oil to prevent rust.
When storing the tool, pull the carriage toward you fully
so that the slide pole is thoroughly inserted into the turn
base.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
3
3. Screw
1
ENGLISH
23

Publicidad

Tabla de contenido
loading

Tabla de contenido