Stacking Kit; Installation Procedure - LG DLEC855W Guía Del Usuario E Instrucciones De Instalacion

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

I
nstallation Instructions

Stacking Kit

In order to stack this dryer an LG stacking kit is
required.
Dryer
Washer
This dryer may only be stacked on top of an LG
washer. DO NOT attempt to stack this dryer on any
other washer, as damage, injury or property damage
could result.
To stack this dryer, the support holder included with
the stacking kit must be used.
Washer Top plate size
23.6 inch
(600mm)
Shape

Installation Procedure

1. Place the LG dryer on the LG Washing machine.
2. Remove two screws at the bottom of the rear cover
on each side as shown below.
8
• Incorrect installation can cause serious
accidents.
• The weight of the dryer and the height of
installation makes the stacking procedure too
risky for one person. This procedure should be
performed by 2 or more experienced service
personnel.
• The dryer is not suitable for a built-in installation.
Please do not install as a built-in.
• Do not operate the dryer is disassembled.
Support Holder
3. Assemble the stacking kit as following.
• Peel the protective film from the double-sided tape on
the bracket for your size washer.
• Attaching the support holder.
• Align the stacking kit holes and the rear cover holes
and then firmly attach the bracket to the side of the
washer in that position.
23.6 inch(600 mm)
Support
Holder
4. Assemble a stacking kit as following.
• Screw 2 screws which were removed earlier to
assemble dryer and stacking kit.
• Use accessory screws [1.2inch (30mm)] to assemble
washer rear cover and stacking kit.
• The procedure for the opposite side will be the
same.
WARNING
F
,

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Dlec855r

Tabla de contenido