Storage; Cutter Plates; Cutter Plates Compatible With Cutter Head Gt647 Cattle; Recommended Combinations - B.Braun Aesculap Instrucciones De Manejo

Aesculap
Bonum large animal battery-operated clipping machine
Adjusting the plate pressure
Note
The plate pressure must be set with the machine running
and without auxiliary tools.
Note
If the plate pressure is too high, this results in the build-
up of heat and greater wear to the cutter plates.
►
Loosen the knurled nut 11 and carefully unscrew adjusting screw 10
until the upper cutter plate 3 is no longer pressing against the lower
cutter plate 2 (the sound of the motor becomes noticeably higher-
pitched, see Fig. A.
►
Screw in the adjusting screw 10 until you feel slight resistance. From
this point, keep turning approximately one full turn and then tighten
the knurled nut 11.
Cleaning the cutter head
►
The cutter head must be cleaned at least after each day of clipping
time or if it gets dirty.
►
Unlock and remove the lithium ion battery 21.
►
Remove both screws 14, see Fig. B.
►
Turn the cutter head very slightly (about 15°) counterclockwise and
remove it from the motor shell.
►
Remove cutter plates; see Changing cutter plates.
►
Thoroughly clean the interior part and individual parts of the cutter
head using a brush.
►
Insert the cutter plate and tighten, see Changing cutter plates.
►
Grease gear wheel, see Greasing gear wheel.
►
Carefully place the cutter head on the motor. When re-attaching the
cutter head, ensure that it is turned 15° counterclockwise in such a
way that its lower flange engages with the groove of the motor hous-
ing.
►
Lubricating the shearing head, see Lubricating the shearing head
Re-sharpen the cutter plates
►
For sharpening the cutting plate, please contact Technical Service, see
Technical Service.
4.6

Storage

►
Clean the clipping machine and cutter plates thoroughly before stor-
ing, see Reprocessing.
►
Store the clipping machine in a dry, dark and clean room.
8
®
5.

Cutter plates

5.1 Cutter plates compatible with cutter head GT647
Cattle version/GT657 Horse version
Art. no. Designation
GT501 Upper cutter plate with 15 cutting teeth
GT502 Lower cutter plate with 31 cutting teeth 3 mm cutting
height
GT503 Upper cutter plate with 17 cutting teeth
GT504 Lower cutter plate with 18 cutting teeth 3 mm cutting
height
GT505 Upper cutter plate with 23 cutting teeth
GT506 Lower cutter plate with 23 cutting teeth 3 mm cutting
height
GT508 Lower cutter plate with 51 cutting teeth 1 mm cutting
height
GT510 Like GT506, but with cutting height of 5 mm
GT511 As GT502, but with cutting height of 1 mm
5.2

Recommended combinations

Combination Upper/lower plate
closely spaced GT501/GT502
teeth
GT501/GT511
GT505/GT502
GT505/GT508
GT505/GT511
medium spaced GT505/GT506
teeth
GT505/GT510
widely spaced GT503/GT504
teeth
Suitable for
Cattle and horses (normal con-
figuration)
Industrial shearing
Horses and cattle – smooth
standard shearing
Horses, cattle (udder shearing)
and industrial shearing
Horses and cattle – for
very?fine, smooth shearing
Cattle, dogs and goats
Dogs and goats
Cattle, sheep and thin-wooled
sheep