Lifting Or Carrying The Garden Shredder; Pulling Or Pushing The Garden; Transporting The Garden Shredder; Circuit Diagram - Viking GE 105 Manual De Instrucciones

● Thoroughly clean all external parts of
the machine.
● Thoroughly lubricate/grease all moving
parts.
12. Transport
Risk of injury!
Before transporting, carefully read
and observe the section "For your
safety", in particular the
"Transporting the machine" section.
( 4.4)
12.1 Lifting or carrying the
garden shredder
At least two persons are always
required to lift and carry the
machine.
Wear suitable protective clothing;
the lower arms and upper part of
the body must be fully covered.
● 1. First person: Hold the garden
shredder at the handle on the upper
chute (1).
● 2. Second person: Hold the garden
shredder at the bar of the ejection chute
extension (2).
● Lift the garden shredder
simultaneously.
12.2 Pulling or pushing the
garden shredder
● Hold the garden shredder at the
handle (1) and tilt to the rear.
0478 201 9910 E - EN
● The garden shredder can be pulled or
pushed slowly (walking pace).
12.3 Transporting the garden
shredder on a load floor
● Secure the machine against
slipping using suitable fastening
materials. Attach ropes or straps to the
wheel carrier (1) or the feed chute (2).

13. Circuit diagram

Item Designation
20
1 Mains plug
2 On / Off switch
3 Capacitor
4 Electric motor
BR brown
BK black
BL blue
YG yellow/green
14. Minimising wear and
preventing damage
Important information on maintenance
and care of the product group
Electric garden shredders
VIKING assumes no liability for material or
personal damage caused by the non-
observance of information contained in the
operating instructions, in particular with
21
regard to safety, operation and
maintenance, or which arise through the
use of unauthorised attachment or spare
parts.
Please always observe the following
important information for the prevention of
damage or excessive wear to your VIKING
machine:
1. Wearing parts
22
Some parts of the VIKING machine are
subject to normal wear even when used
properly and must be replaced in due time
depending on type and duration of use.
These include:
– Blade
– Blade disc
2. Compliance with the information in
this instruction manual
23
The VIKING machine must be used,
maintained and stored with the care
described in this instruction manual. Any
damage caused by non-compliance with
the safety, operating and maintenance
instructions is the sole responsibility of the
user.
This applies in particular to:
– Inadequately dimensioned power
cables (cross section)
– Incorrect electrical connection (voltage)
– Product modifications not approved by
VIKING
– Use of tools or accessories which are
not approved or suitable for the
machine, or are of inferior quality
– Improper use of the product
– Use of the product for sporting or
competitive events
– Resultant damage due to continued use
of the product with defective
components.
37