Electrical Connection - Beem Fresh-Aroma-Perfect Deluxe Version 2 Manual De Instrucciones

EN
Requirements for the place of
operation
For safe and trouble-free operation of the
appliance, the installation location must sat-
isfy the following requirements:
■ Place the appliance on a firm, dry, flat,
waterproof and heat-resistant surface.
■ The surface finishes on furniture may
contain substances that can be detri-
mental to the feet of the appliance. If
necessary, place a mat under the feet of
the appliance.
■ Do not place the appliance onto a table-
cloth.
■ Do not install the appliance in a hot, wet
or very humid environment.
■ Select a location that does not allow
children to reach the hot surfaces of the
appliance.
■ The mains socket must be easily acces-
sible and allow fast disconnection in the
event of an emergency.
■ Make sure that there is a sufficient dis-
tance to heat-sensitive surfaces to walls
and furniture for example.
■ Do not place the appliance in the vicinity
of curtains or underneath a wall-mount-
ed cupboard.
■ The appliance may not be used or
stored outdoors.
BEEM - Elements of Lifestyle
Fresh-Aroma-Perfect Deluxe

Electrical connection

For safe and trouble-free operation of the
appliance, the following instructions on the
electrical connection must be be observed:
■ Before connecting the appliance, com-
pare the connection data (voltage and
frequency) on the rating plate with those
of your mains power supply. This data
must correspond in order to avoid dam-
age to the appliance. If in doubt, ask
your electrical appliance retailer.
■ The mains socket must be protected by
at least a 16 A fuse.
■ If the appliance is to be connected to
the power supply via an extension lead,
the cable cross-section must be at least
1.5 mm².
■ Ensure that the mains cable is undam-
aged and is not laid over sharp edges or
hot parts.
■ The mains cable must not be pulled
tightly, bent or come into contact with
hot surfaces.
■ Route the mains cable to prevent risk of
tripping.
■ The electrical safety of the appliance
is only assured when it is connected
to a properly installed protective earth
(PE) conductor system. Connection to
a mains socket without PE conductor
is forbidden. If in doubt, the electrical
system must be checked by a qualified
electrician. The manufacturer assumes
no liability for injury or damage caused
by a missing or interrupted protective
earth conductor.
23