Troubleshooting - Ryobi RY40LM01 Manual Del Operador

IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.
PROBLEM
Handle not in position.
Mower not starting.
Mower cutting grass unevenly.
Mower not mulching properly.
Mower hard to push.
Mower not bagging properly.
Mower vibrating at higher speed.
Motor stops while cutting.
This product has a Five-year Limited Warranty for personal,
family, or household use (90 days for business or commercial use).
For warranty details, visit www.ryobitools.com

TROUBLESHOOTING

POSSIBLE CAUSE
Handles not locked
Battery is low in charge.
Start key not installed.
Handle assembly is not in operating
position.
Mower is in a vertical position or tilted
at an angle greater than 45º.
The metal lock(s) on the grass catcher
or mulching plug is not fully seated in
the slot(s) on the mower housing.
Lawn is rough or cutting height not set
properly.
Wet grass clippings sticking to the un-
derside of the deck.
High grass, rear of mower housing and
blade dragging in heavy grass, or cut-
ting height too low.
Cutting height set too low.
Blade is unbalanced, excessively or
unevenly worn.
Bent motor shaft.
Cutting height set too low.
or call (toll free) 1-800-860-4050.
13 — English
SOLUTION
Step on the foot pedal and pull the
handle assembly back until it locks into
place. Extend the upper handle and lock
into place.
Charge the battery.
Install start key.
Make sure the handle assembly is in the
operating position.
Place the mower in a horizontal position.
Gently push down on the metal lock(s)
to ensure it is fully seated in the slot(s).
Adjust the cutting height.
Wait until the grass dries before mowing.
Raise cutting height.
Raise cutting height.
Replace the blade.
Stop the motor, remove start key and
battery. Inspect for damage. Have re-
paired by an authorized service center
before restarting.
Raise the cutting height.