Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Product Dimensions
D
A
B
C
E
F
N
A.
1.09 m (43")
B.
970 mm (38
⁄
")
1
8
C.
890 mm (35")
D.
38 mm (1
⁄
")
1
2
E.
705 mm (27
⁄
")
3
4
F.
650 mm (25
1
⁄
")
2
G.
Water inlets
H.
180 mm (7")
Drain System
Standpipe Drain System
The standpipe drain requires a minimum diameter standpipe of
50 mm (2"). The minimum carry-away capacity can be no less
than 64 L (17 gal.) per minute.
The top of the standpipe must be at least 990 mm (39") high
and no higher than 1.83 m (72") from the bottom of the washer.
H
I
Cold
K
J
Hot
G
O
P
L
M
I.
Power supply cord
J.
Drain hose connector
K.
Label
L.
685 mm (27")
M.
133 mm (5
⁄
")
1
4
N.
25 mm (1")
O.
Water level switch and shaft
P.
127 mm (5")
Electrical Requirements
A 220–240 volt, 50 Hz., AC only, 10-amp, fused electric
n
supply is required. A time-delay fuse or circuit breaker
is recommended. It is recommended that a separate circuit
serving only this appliance be provided.
This washer is equipped with a power supply cord having
n
an earthing plug. The plug should be accessible for
disconnection from the supply.
If the supply cord is damaged, it must be replaced by the
n
manufacturer, its service agent, or similarly qualified persons
in order to avoid a hazard.
Using the universal cord included with this washer:
This washer is equipped with a universal cord with
interchangeable mains plugs.
1. Select the appropriate mains plug assembly from those
supplied and attach it to the mains cord connector.
2. Snap the 2 halves of the cord lock together over the
connector to retain it in position.
5
Publicidad
Tabla de contenido
