POLTI SV420_FRESCOVAPOR Manual De Instrucciones página 20

before connecting the appliance to the mains and before use.
Always use the product with the cable completely unwound
• Do not pull or jerk the cable or expose it to tensions (twisting,
crushing or stretching). Keep the cable away from hot and/or
sharp surfaces and elements. Avoid crushing the cables in
doors and windows. Do not pull the cable tight around cor-
ners. Avoid treading on the cable. Do not pass over the cable
with the appliance. Do not wind the power cable around the
appliance, especially if the appliance is hot.
• Do not substitute the plug on the power cable.
• If the power cable is damaged, it must be replaced by the manu-
facturer, its service agent or similarly qualified persons in order
to avoid all possible hazards. Do not use the product if the
power cable is damaged.
• Do not touch or use the appliance barefoot and/or with wet
body or feet.
• Do not use the appliance near containers full of water, e.g.
sinks, baths and swimming pools.
• Never immerse the cleaner in water or other fluid.
• A hazard may occur if the appliance runs over the supply cord.
• Steam must not be directed towards equipment containing
electrical components, such as the interior of ovens.
RISKS DURING USE OF THE PRODUCT – INJURIES/SCALDING
• The product should not be used in areas where there is a dan-
ger of explosions or in the presence of toxic substances.
• Do not pour toxic substances, acids, solvents, detergents, cor-
rosive substances and/or explosives or perfumes into the tank.
• Only pour water or the water mix indicated in the Chapter
"WHICH WATER TO USE" into the tank.
• Do not direct the steam jet onto toxic substances, acids, sol-
vents, detergents or corrosive substances. The handling and re-
moval of dangerous substances must be carried out according
to the indications of the manufacturers of these substances.
• Do not direct the steam jet onto explosive powders or liquids,
hydrocarbons, open flames and or extremely hot objects.
| 20 |