Troubleshooting - POLTI SV420_FRESCOVAPOR Manual De Instrucciones

10. TROUBLESHOOTING

PROBLEM
The appliance does not turn on.
No steam is coming out
PROBLEM
The appliance is on but relea-
ses little steam
The appliance releases too
much water on the floor
FrescoVapor deodorant is not
released when using steam.
Steam too damp using Fre-
scoVapor.
If problems persist or are not listed above, please contact a Polti Authorised Service Centre
(www.polti.com for the updated list) or contact Customer Services.
CAUSE
No power.
Out of water.
Appliance turned off.
ONLY FOR THE SV420_FRESCOVAPOR MODEL
CAUSE
The steam is set to the
minimum level
Steam adjustment dial
set to the maximum.
Deodorant selector in OFF
position.
Check the FrescoVapor
level
The steam is mixing with
FrescoVapor.
SOLUTION
Check that the appliance has
been
mains, as indicated in Section 1.
Disconnect the appliance from
the mains, fill the water tank
and wait about 15 seconds, af-
ter which use the appliance.
Check that the appliance has
been disconnected from the
mains, as indicated in Section 1.
SOLUTION
Turn the steam adjustment
knob to increase the flow.
Reduce the quantity of steam
to the minimum. If necessary,
momentarily stop the disbur-
sement of steam, while conti-
nuing to rub the surface.
Place the selector in the ON
position.
Fill the dispenser with Fresco-
Vapor
Stop the dispensing of Fresco-
Vapor as desired, to reduce the
humidity of the steam.
| 25 |
disconnected from the