POLTI SV420_FRESCOVAPOR Manual De Instrucciones página 23

3.4 The brush has a flexible joint that makes it
easy to also clean corners and edges of furni-
ture and walls.
During cleaning, it is possible to insert the
power cable into the upper hook, to avoid it
possibly getting in the way (9).
The brush has bristles built into the rear side
(10) ideal for removing the most stubborn
dirt. To use, return the handle to the vertical
position locking the brush, then tilt until the
brushes are touching the floor and scrape off
the dirt.
Before removing the cloth from the brush,
wait a few minutes to allow the cloth to cool.
After which, rest a foot on the symbol relati-
ve to the tab of the cloth and pull the steam
broom upward.
WARNING: Do not
without the cloth.
WARNING: For additional safety, test steam
delivery on a hidden part, leave the steamed
part to dry to ensure that no changes in co-
lour or deformations have occurred.
4. CLEANING CARPETS AND RUGS
WARNING: Before cleaning fabrics with
steam, consult the manufacturer's instructions
and always carry out a test on a hidden part or
on a sample of the material. Allow the stea-
med part to dry to make sure that no changes
in colour or deformations have occurred.
Ensure that the points in Sections 1 and 2 have
been followed.
4.1 Insert the brush with the cloth attached in-
to the special frame so that it can slide on the
surface (11).
4.2 For the SV420 model Adjust the intensity
of the steam by turning the adjustment knob
(7); for this type of surface we recommend
Medium level of steam.
4.3 Release the appliance brush by tilting it
backward and using a foot, then press the
steam button (8) on the handle, and begin
cleaning moving the broom back and forth. To
stop the steam flow, release the steam button.
During cleaning, it is possible to insert the
power cable into the upper hook, to avoid it
possibly getting in the way (9).
use the appliance
4.4 To remove the frame, just rest a foot on
the relative symbol
broom upward.
5. FRESCOVAPOR
only for the SV420 model
WARNING: Never put FrescoVapor into the
water tank.
FrescoVapor is a air freshener that contains
natural substances. Designed to mix with
steam it releases a fresh perfume in every
space and, thanks to its special composition,
it is able to eliminate bad odours.
To use FrescoVapor, proceed as follows:
- Unscrew the deodorant dispenser cap loca-
ted on the floor brush and fill it with Fresco-
Vapor (12).
- Tighten the cap (12).
- To start dispensing the deodorant, press the
selector located on the brush to the "ON" po-
sition to release the deodorant. Press the se-
lector back to the "OFF" position to stop it
(13).
During dispensing of the deodorant, the sur-
faces may feel slightly damper, since Fre-
scoVapor mixes with the steam being di-
spensed. To stop dispensing FrescoVapor,
move the selector located on the brush to
the OFF position.
The selector only controls dispensing of the
deodorant that mixes with the steam. It does
not regulate the quantity of steam. To adjust
the quantity of steam, you must use the
steam-adjustment dial (7).
Contents of the FrescoVapor bottle: 200 ml
FrescoVapor is on sale at household applian-
ce stores, at Polti authorised service centres
or on the site www.polti.com.
WARNING:
- Keep out of the reach of children.
- IF SWALLOWED: Rinse mouth; do NOT in-
duce vomiting.
- Avoid contact with eyes, skin or clothing.
- Do not release into the environment.
| 23 |
and pull the steam