Bornay 600 Manual De Usuario página 53

System reset:
On connecting the apparatus, or if it is reset for any reason, the regulator will
show a screen, as follows, depending on which model it is:
The topmost line on the screen shows the regulator model. From left to right it
shows: the wind turbine power; the wind turbine voltage; and the maximum
current it accepts. The bottom line on the screen shows the system version.
NOTE:
If the batteries have become excessively run down for any reason or if regulator
malfunction is detected, RESET can be used to check if the equipment returns to
normal functioning.
To use RESET, there is a printed circuit board micro switch located on the
regulator's control card, i.e. under the regulator cover.
If the error persists, contact the manufacturer.
A:010 V: 27.3 19C
(600W)
Jb114v2
Bornay 600 – Rev 6.0 - P 53
24V 28A
271006