Tennant 9002756 Manual Del Operador página 5

After 20 / 30 minutes the machine is usually
ready to start to work again.
During this dead time (which is necessary
for the motor to be cooled down),
The Vacuum Cleaning machine is supplied ready
to use. It consists of a tank mounted on wheels,
cover with handle, filter cartridge and an exhaust
filter. In the pack, you will have the following: hand
pipe (two pieces), elbow, flexible suction hose,
floor tool and paper filter bag.
Assemble the two straight pipes and elbow
by simply pushing them together. Now fit
the floor tool to the lower end of the straight
pipe and connect the end of the suction
hose to the elbow section.
Home
Ensure that the paper filter bag and filter cartridge
are in the tank of the machine and correctly
positioned. Always ensure that filters are clean
and serviceable and that the suction hose, wand
and floor tool are not blocked. Connect the plug
to the main power supply and switch the machine
on by pressing the on/off switch.
Switch the machine off by pressing the on/off
switch. Disconnect the plug from the main power
supply wall socket. Do not pull on the cable as it
may be damaged. Always wind up the cable and
hang it on the handle/cable hanger on the top
cover of the machine.
Regular maintenance has three stages:
*
*
*
*
*
*
*
*
Please use only original filters and take note of the
instructions on the filter or filter pack!
Spare filters can be purchased from your distributor.
Please note that only genuine filters are guaranteed
to give a constant high filter performance.
Find... Go To..
Visually inspect machine for any damaged parts,
damaged cables or electrical connections and
check that the paper filter bag is neither full nor
damaged.
Check the brush strips on the floor tool Ð if
brushstrips are worn out, floortool should be
exchanged.
Check the cartridge filter - should it be cleaned
or replaced.
Clean the cable and inspect for damaged
insulation.
Clean and lubricate the wheels and castors.
Check all machine functions.
5