Switching On The Machine; Display "Infeeding Film; Anti-Chrystalisation Function / Anti-Oxidisation Function - Protec ECOMAX Manual De Instrucciones

Operation

Switching on the machine

The processor is switched on at the main switch (front right). The developer bath
will be heated up. The LED flashes during the warm-up phase and no X-ray film
must be inserted into the machine during this time. When the machine is ready, a
acoustic signal is heard and the LED is on continuously.

Display "Infeeding film"

If films are fed into the processor without gap one after another, then this may cause
a film jam. The "Feeding film" LED flashes as long as a film is fed. Once the film has
been fed completely the LED is on continusouly. Additionally an acoustic signal in-
dicates that the next film can be inserted.
Both chemicals pumps - for fixer and developer - are driven in
parallel by only one motor and therefore always run simultane-
ously. The regeneration volumes for developer and fixer thus
are identical.
Anti-crystalisation function
During the stand-by mode, the film transport, the dryer ventilation, the dryer heating
and the water inflow are activated every 20 minutes for a period of 20 seconds. This
prevents the build-up of crystals on the rollers.
Anti-Oxidisation Function
Also during the stand-by, the developer chemicals are subject to change which
causes their deterioration. By means of the time replenishment, a replenishment cy-
cle is activated after 60 minutes without replenishment. The pump runs for
10 seconds. With this function, the quality of the developer chemicals are main-
tained even when standing idle for long periods.
Please note:
High or low room temperature can influence the function of the
film processor.
ECOMAX
TM
18