Playing Back Music On A Computer - Teac AI-503 Manual Del Usuario

Installing the driver on a computer
This unit can be connected with computers running the following
operating systems . Operation with other operating systems is not
guaranteed (as of October, 2016) .
When using Mac
The driver works with the following versions .
OS X Lion (10 . 7 )
OS X Mountain Lion (10 . 8 )
OS X Mavericks (10 . 9 )
OS X Yosemite (10 . 1 0)
OS X El Capitan (10 . 1 1)
macOS Sierra (10 . 1 2)
This unit can be used with the standard OS driver . For this reason,
there is no need to install a special driver or anything else .
When using Windows
The driver works with the following versions .
Windows 7 (32/64-bit)
Windows 8 (32/64-bit)
Windows 8 . 1 (32/64-bit)
Windows 10 (32/64-bit)
Installing the driver on the computer
In order to play audio files stored on a computer through this unit,
you must install a dedicated driver on that computer beforehand .
Download the dedicated driver from the TEAC Global Site .
TEAC Global Site
http://teac-global.com/
ATTENTION
Install the dedicated driver before connecting the unit with
the computer by USB.
If you connect this unit with a computer before installing the driver,
it will not work properly .
o For instructions about driver installation procedures, access the
Downloads page from the TEAC Global site (http://teac-global . c om/) .
o Depending on the combination of hardware and software, proper
operation might not be possible even with the above operating
systems .

Playing back music on a computer

About transmission mode
This unit connects using high-speed asynchronous mode .
The sampling frequencies that can be transmitted are 44 . 1 , 48, 88 . 2 ,
96, 176 . 4 , 192, 352 . 8 and 384 kHz .
When properly connected, you will be able to select "TEAC USB
AUDIO DEVICE" as an audio output from the computer OS .
o In asynchronous mode, the audio data sent from the computer
is processed using this unit's clock, reducing data transmission
jitter .
Downloading playback application TEAC
HR Audio Player
You can download Mac and Windows versions of our free TEAC HR
Audio Player application that supports playback of DSD files from
the TEAC Global Site (http://teac-global . c om/) .
TEAC HR Audio Player setting note
To play 11 . 2 MHz DSD recordings with TEAC HR Audio Player, open
the Configure window and set the "Decode mode" to "DSD Native . "
To play formats other than 11 . 2 MHz DSD, you can set this to either
"DSD over PCM" or "DSD Native" as you like .
For details, see "Selecting DSD decoding mode" in the TEAC HR
Audio Player Owner's Manual .
EN
19