Fore And Aft, Rotation; Side To Side/Width Adjustment; Foot Straps - Zippie Pluton Manual De Usuario

Fore and Aft, Rotation

• Turn Locking Screws E anti-clockwise half a turn
using the 4mm Allen Key provided.
• Slide the entire foot holder forwards or backs whilst
simultaneously setting the rotation of the plate.
• Once the desired position has been acquired
re-secure the locking screws to hold back in place.

Side to Side/Width Adjustment

• Pull and hold open Plunger F, whilst maintaining hold
of the footplate with your other hand.
• Once disengaged, the footplate holder should be free
to slide sideways, bringing the feet together/apart as
required.
• When you have achieved the desired position, you
should release the Plunger to engage it within the
closest available location hole.
• Ensure the plunger is fully engaged before
commencing use of the chair.

Foot Straps

Foot straps or ankle huggers can be attached through the
slots in the sandal to secure feet. Feed the strap through
the buckle and close the buckle shut to secure.
WARNING!
Do not use foot straps unless the client is wearing shoes.
CAUTION!
• Plunger C should pull out freely, if resistance is felt
ensure no weight is being put through the footrest.
• Footplate Angle – As an Alternative you can position
the Footplate without pressing down the handwheel,
though this has potential to shorten the life of the
locking mechanism and is therefore not
recommended.
Pluton Rev.1.0
Fig.21.3
F
27