Charging Battery; Led Display On Charger - Viking MA 443 Manual De Instrucciones

Installing battery:
● Insert battery (1) into battery
compartment as shown applying slight
pressure and close cover.

8.4 Charging battery

● Remove battery from battery
compartment ( 8.3).
● Connect charger to the mains (
● Push battery (1) into charger (2) until
first resistance is felt, then press to
stop. Green LED on battery and
charger (3) indicate that charging is
active.
● When battery is fully charged, LEDs on
battery and charger extinguish.
Remove battery from charger and insert
in battery compartment (
Charging procedure
The charger automatically detects the
battery type and adapts the charging
process accordingly.
The batteries are cooled during the
charging process – via a fan on the quick
charger (AL 300, AL 500) and with the
natural air current in the room on the
standard charger (AL 100).
The LEDs on the battery indicate the
charging status ( 8.5).
When the battery is fully charged, the
charger switches off automatically and the
LEDs in the battery and charger
extinguish.
The charging time depends on various
influencing factors such as e.g. the battery
condition and ambient temperature and
can therefore deviate from the specified
charging times ( 19.).
0478 131 9922 C - EN
If a warm battery is inserted in the charger,
the charging time may increase because
the battery must cool down before the
charging process begins.

8.5 LED display on charger

● Press button (1) in order to
8
activate the display – display
extinguishes automatically after
8.2).
5 seconds.
LED displays:
The LEDs can illuminate or flash green or
red.
LED illuminates green.
LED flashes green.
LED illuminates red.
8.3). LED flashes red.
Green LEDs indicate normal operation,
red LEDs indicate a malfunction.
During charging:
Illumination and flashing of the LEDs
indicate the charging status.
During charging, the momentary charge
capacity is indicated by a green flashing
LED.
When charging is complete, the LEDs
extinguish automatically.
During work:
Illumination and flashing of the LEDs
indicate the charge state.
9
Faults
One LED illuminates red
During charging:
Battery is too warm or too
cold for the charging
process to start. Once the battery has
cooled down or warmed up, the charging
procedure starts automatically.
During work:
Battery is too warm.
Machine switches off –
remove the battery from the lawn mower
and allow to cool for a period.
Four LEDs flash red
The battery is defective
and must be replaced.
Three LEDs illuminate red
The lawn mower is
overheated – allow it to
cool down.
Three LEDs flash red
The lawn mower is
defective and must be
checked by a specialist
dealer. VIKING recommends VIKING
specialist dealers.
43