Select And Install The Table Insert; Connect To Dust Collector - Delta 31-483 Manual De Instrucciones

SELECT AND INSTALL THE
TABLE INSERT
Failure to use the proper insert with the corresponding spindle may result in injury and/or damage to the
machine or the work piece.
Your DELTA ® Heavy Duty Oscillating Bench Spindle Sander comes with four table insert plates. The two table inserts
with the smaller diameter openings are designed for use with the ¼", ½", and
inserts with the larger openings are designed for use with the 1 ½' and 2" sanding spindles.
The table inserts with the round openings are designed for sanding jobs where the table is in the fully horizontal position.
The table inserts with the oblong openings are for beveled sanding.
SPINDLE SIZE RECOMMENDED TABLE INSERT
(diameter) Opening Size
¼" Small
½" Small
5
/ " Small
8
1 ½" Large
2" Large
FIGURE 5
• Using the recommended table inserts shown in Figure
5, select the desired table insert.
• Slip the table insert over the spindle. Ensure the table
insert is properly seated by aligning the small notch in
the table insert with the corresponding small tab in the
table as shown in Figure 6.
CONNECT TO A DUST COLLECTOR
®
Yo u r D E LTA O s c i l l at i n g B e n c h S p i n d l e S a n d e r
is equipped with a 2" to 4" dust port adaptor that
enables you to attach it to a standard dust collection
system using either a 2" or 4" connection. This must
be connected to dust collector hoses to ensure safe
operation.
Do not attempt to operate this tool
without first connecting it to an adequate
dust collection system.
Always turn on the dust collector before
starting the sander and always stop the
sander before turning off the dust collector.
Locate the 2" diameter dust outlet on the rear of the
machine (see Figure 7).
If your dust collector uses a 2" hose, attach it by fitting
the hose over the existing dust port on the back of the
sander.
If your dust collector has a 4" hose, fit the supplied 2" to
4" adaptor over the existing dust port on the machine,
then attach the hose from your dust collector to the 4"
outlet on the adaptor.
ASSEMBLY
Opening Shape
Oblong or Round
Oblong or Round
Oblong or Round
Oblong or Round
Oblong or Round
9
5
/ " sanding spindles while the two table
8
FIGURE 6
FIGURE 7