How To Prepare The Machine For Operation; Battery Connections; How To Handle The Packed Machine; How To Unpack The Machine - Clarke 00310S Operator's Manual

ENGLISH
EN

How To Prepare the Machine For Operation

How To Handle the Packed Machine

The machine is packed in a specifi c package provided on a pallet so that
it can be moved with a forklift.
WARNING: The packages cannot be placed on top of
each other.

How to Unpack the Machine

1. Remove the outer package.
2. The machine is fi xed on the pallet with banding straps and
wooden blocks to prevent movement during shipment. Remove
the bands and blocks.
3. The machine is shipped with the batteries already installed.
4. Remove tie down brackets.
5. Lower the ramp. The machine can be driven off of the pallet if
the operator is thoroughly familiar with its operation. Avoid violent
blows to the base unit.
6. Keep the pallet for future transport necessities.

How to Install the Batteries

WARNING: The batteries are heavy. Lifting batteries
without help could result in an injury. Get
help to lift the batteries.
WARNING: Working with batteries can be dangerous.
Always wear eye protection and protective
clothing when working near batteries. NO
SMOKING!
WARNING: Hydrogen gas is formed during the charging
operation and is explosive. Only charge bat-
teries in a well ventilated area with the seat
base lifted.
The batteries are fi tted in the battery compartment under the seat and
recovery tank (fi gure 3). The machine uses six - 6 volt batteries. They
must be handled by using appropriate lifting equipment suitable for the
weight and for the coupler system. For maintenance and daily recharge
of the batteries, it is necessary to follow all instructions given by the
manufacturer.
For Battery Installation follow these steps (See fi gure 3):
1. Make sure that the key switch is in the "OFF" position.
2. Lift and rotate the base support of the seat forward.
3. Lean the seat on it's restraint cable.
4. Lift the front of the recovery tank and rotate it towards the rear
until it rests on it's restraint cable.
5. Put the batteries into position and connect the battery cables as
shown in fi gure 3.
6. Rotate the recovery tank and then carefully rotate it forward to the
normal operating position.
7. Lower the base support of the seat.
NOTE: Charge the batteries before using.
Page -10- Form No. 71171A

BATTERY CONNECTIONS

Front of
machine
370 AH, 6 Volt
(Battery No. 40704A Wet)
(Battery No. 40602A Dry)
Front of
machine
330 AH, 6 Volt
(Battery No. 891384 Wet)
(Battery No. 891385 Dry)
Front of
machine
250 AH, 6 Volt
(Battery No. 881317 Wet)
(Battery No. 881318 Dry)
Three (3) 70222A Spacers
Figure 3
Clarke ® Operator's Manual (EN) - Focus Rider