How To Install And Remove The Brush Or Pad On The Boost Head - Clarke 00310S Operator's Manual

How To Prepare the Machine For Operation
How To Install The Brush Or Pad on the BOOST machine
To install the brush or pad on the BOOST machine, follow this pro-
cedure:
1. Turn the key switch "ON".
2. Put the brush switch in the "UP" position.
3. Turn the key switch "OFF".
4. Go to the side of the machine.
5. Press on a brush or pad under the fl ex plates. See fi gure 15.
NOTE: When using a black pad, position pad on head.
Lower head and operate momentarily to affi x pad to
pad driver (if you have diffi culty, position pad on
fl oor and lower head then operate.)
How To Remove The Brush Or Pad on the BOOST
machine
To remove the brush or pad from the machine, follow this proce-
dure:
1. Turn the key switch "ON".
2. Put the brush switch in the "UP" position.
3. Turn the key switch "OFF".
4. Go to the side of the machine.
5. Pull downward on the brush or pad until it releases from the
fl ex plates. See fi gure 16.
Clarke ® Operator's Manual (EN) - Focus Rider
ENGLISH
EN
Figure 15
Figure 16
Form No. 71171A - 15 -