Transport, Storage And Disposal; Venting The Appliance - Melita CAFFEO CI Serie Manual De Instrucciones

Removing the water fi lter
The Melitta Claris
®
not remain dry over an extended period
of time. It is therefore recommended to
store the Melitta
®
refrigerator in a glass of water when the
appliance will not be in use for extended
periods.
• Flip up the lid of the water reservoir 6.
• Pull the water reservoir 6 up and out of
the appliance.
• Unscrew the water fi lter from the thread
on the base of the water tank.
• Reinsert the water reservoir 6.
• Call up the Care sub-menu.
• Select Filter in the menu.
• Select Remove fi lter in the menu.
• Select Start in the menu.
• The prompt "Filter has been removed,
set water hardness" is shown appears
on the graphic display 4.
• Set the water hardness (Page 30).
Transport, Storage and
Disposal

Venting the appliance

Warning!
Danger of burning and scalding
from hot steam
The machine releases hot steam when
it is vented. Never allow any part of
your body, e.g. your face to come into
contact with the hot steam.
It is recommended to vent the appliance
if it will not be used for an extended
period of time and before transport. This
also protects the appliance against frost
damage.
36
BA_CI_042015.indd 36 BA_CI_042015.indd 36
water fi lter should
®
Claris water fi lter in the
®
• Remove the water fi lter if necessary
(Page 36).
• Place a vessel under outlet 3.
• Call up the System sub-menu.
• Select Venting in the menu.
• Select Start in the menu.
• Flip up the lid of the water reservoir 6
and pull the water reservoir 6 up and out
of the appliance.
• Connect the tube to the drip tray and to
the outlet (Image D).
• Press the rotary switch 10 to confi rm.
The appliance heats up.
• The appliance is vented and then
switches off completely.
Transport
• Vent the appliance.
• Empty and clean the drip tray and coffee
grounds container.
• Empty the water reservoir and th bean
container. If necessary, vacuum out
beans that are stuck at the bottom.
• Secure loose parts (cup plate etc.) with
suitable adhesive tape.
• If possible, transport the appliance in
the original packaging including the hard
foam elements.
Disposal
This appliance is labelled according to
the European Directive 2002/96/EC on
waste electrical and electronic equipment
(WEEE). The Directive prescribes the
framework for a EU-wide applicable return
and recycling of waste appliances. Please
contact a specialised dealer for current
disposal procedures.
20.04.2015 20:45:12 20.04.2015 20:45:12