Measuring Blood Pressure - Beurer BM 47 Manual De Instrucciones

Setting the date and time
It is essential to set the date and time. Otherwise, you will
not be able to save your measured values correctly with a
date and time and to access them again later.
The time is displayed in the 24-hour format.
To set the date and time, proceed as follows:
• Press the memory button M for at least three seconds.
• The year display will start to flash. Set the year with the func-
tion buttons -/+ and confirm with the memory button M.
• Set the month, day, hour and minutes and confirm each
setting with the memory button M.

5. Measuring blood pressure

Please ensure the unit is at room temperature before meas-
uring.
Attach the cuff
Place the cuff on to the bare left
upper arm. The circulation of the
arm must not be hindered by tight
clothing or similar.
The cuff must be placed on the
upper arm so that the bottom
edge is positioned 2 – 3 cm above
the elbow and over the artery. The
line points to the centre of the
palm.
Now tighten the free end of the cuff,
but make sure that it is not too
tight around the arm and close the
Velcro fastener. The cuff should be
fastened so that two fingers fit
under the cuff.
Now insert the cuff line into the
connection for the cuff connector.
Caution: The unit may only be operated with the original
cuff. The cuff is suitable for an arm circumference of 22 to
35 cm.
A larger cuff for upper arm circumferences from 30 to 42 cm
is available from retailers or the service address under order
no. 162.795.
20