Troubleshooting - HOLZMANN MASCHINEN FS 160L Manual De Instrucciones

15

TROUBLESHOOTING

Disconnect the machine from the power supply prior to any checks performed at the
machine itself !
Trouble
Machine does not
start
Thermal motor
protection is
activated after a
short period
Spindle does not
come to full speed
inadequate milling
vibrating machine
Edge splinter during
milling transverse to
the wood fibers from
HOLZMANN MASCHINEN GmbH
Possible cause
 Blown fuse or circuit breaker fallen
 defective power line
 limit switches activated
 Extend or corded undersized or
defective
 Motor overload due to taut belts
 Motor overload due to rapid
workpiece feed
 Motor overload caused by blunt
cutting blades
 insufficient or fluctuating power
supply
 Extension cable too long or too
small cross section
 blunt cutting blades
 Deposited resin, etc. on blade
profile
 Incorrect combination of speed,
feed and depth of cut
 unbalanced milling head
 Crane standing on uneven or
slightly oscillating floor
 defective belt
 Belts tensioned false
www.holzmann-maschinen.at
TROUBLESHOOTING
Solution
 Replace or activate
 Replace or repair
 Close maintenance door
 Replace
 Adjust belt tension
 Reduce work feed and do
not overload
 replace cutting blades
 contact Electricians
 Blank check Electricians
 replace cutting blades
 Clean, ATTENTION: sharp
edges
 the right choice depends on
the situation and experience
value
 Replace
 Provide machine on flat hard
ground
 Replace
 Correct belt tension
 the first milling gently
against spindle rotation
 the second milling with
minimal milling reduction
with spindle rotation
39
FS 160L