Bosch 4100 Instrucciones De Funcionamiento página 80

Make sure the teeth of the ANTIKICKBACK pawls are always
sharp. To sharpen:
1. Remove blade guard.
2. Rotate pawl toward rear of spreader so that teeth are above top
of spreader.
3. Hold spreader with pawl over corner of workbench (Fig. 68).
4. Using a small round file (Smooth Cut) sharpen the teeth.
All repairs, electrical or mechanical, should be
attempted only by trained repairmen. Contact the
nearest Factory Service Center or Authorized Service Station or
other competent repair service. Use only identical replacement
parts, any other may create a hazard.
Lubrication
The gear case has been completely lubricated at the factory.
However, after six months to one year, depending upon use, it's
wise to return your tool to the nearest Service Center for the
following:
* Brushes replaced.
* Parts cleaned and inspected.
* Relubricated with fresh lubricant.
* Electrical system tested.
* All repairs.
The following parts should be oiled occasionally with SAE No. 20 or
No. 30 oil, or WD 40 (Fig. 69).
1. Elevation, support rods, and gears.
2. Sliding rails and supports.
3. Table locking cams (Front & Rear).
\
Recommended Accessories
item Cat. No.
Rear Outfeed Support .................................. TS1002
Left Side Outfeed Support .............................. TS1003
Dust bag ............................................... TS1004
Zero Clearance Insert ................................... TS1005
Dado Insert Set ......................................... TS1007
Molding Insert .......................................... TS1009
Pusher Guide System ................................... TS1010
Blade Tote .............................................. TS1011
Gravity-Rise Wheeled Table Saw Stand .................. TS2000
Use only recommended accessories. Follow
instructions that accompany accessories. Use of
improper accessories may cause hazards.
80.