EINHELL CE-CP 18/180 Li E Manual De Instrucciones Original página 25

10. Faults
a) The equipment does not work
Check that the battery is charged and whether the charging unit is working.
b) An error code is displayed
Error code
E1 - The rechargeable battery is subject to
excessive current.
- Equipment defect
E3 - The equipment cannot start up be-
cause of, e.g. pressure load
- Equipment defect
E4 - The motor is overloaded
- Equipment defect
E5 - The equipment has been running for a
lengthy period of time and has become
hot.
E6 - The low-voltage protection has swit-
ched off the rechargeable battery.
E7 - Mechanical problem (gear unit)
E8 - Mechanical problem (motor)
E9 - The overvoltage protection has swit-
ched off the rechargeable battery.
If the equipment will not work in spite of the troubleshooting measures and the voltage supply being OK,
please send it to the customer service address below.
Anl_CE_CP_18_180_Li_E_Solo_SPK9.indb 25 Anl_CE_CP_18_180_Li_E_Solo_SPK9.indb 25
GB
Possible cause
- 25 -
Possible remedial measures
- Change the rechargeable battery
- Have the equipment start up in idle
mode
- Check whether the equipment can
start up unhindered
- Change the rechargeable battery
- Have the equipment start up in idle
mode
- Check whether the equipment can
start up unhindered
- Change the rechargeable battery
- Have the equipment start up in idle
mode
- Allow the equipment to cool for about
30 minutes. It will only run again when
there has been a signifi cant decrease
in the temperature of the equipment
again.
- Change the rechargeable battery
- Charge battery
- Check whether the equipment can
start up unhindered
- Change the rechargeable battery
- Have the equipment start up in idle
mode
- Check whether the equipment can
start up unhindered
- Change the rechargeable battery
- Have the equipment start up in idle
mode
- Change the rechargeable battery
- Check the voltage of the rechargeable
battery (max. 21V)
03.07.2019 08:34:39 03.07.2019 08:34:39