Electrical Connection - CASO DESIGN EMGS 25 Manual Del Usuario

 Place the microwave device as far away from radios of TVs to minimize any
interference to radio and TV reception.
 This device is only intended for domestic use.
 This device is intended for built-in use only. It is not intended for counter-top use or for
use inside a cupboard.
 The device may only be operated when the door of the built-in furniture is open.

13.5.2 Electrical connection

DANGER: Risk of electrocution
► Touching internal compponents may cause serious, severe and fatal injuries.
► Do not disassemble the device.
► Improper grounding can cause electrical shocks. Do not use a power outlet if it is not
properly installed and grounded.
In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:
 Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device. If in doubt, ask your qualified electrician.
 Make sure that the power cable is undamaged and has not been installed under the
device or over hot or sharp surfaces.
 This device must be electrically grounded. In case of a short circuit grounding will
protect against electric shocks because the electrical current is diverted through the
grounding lead. The device is fitted with an appropriate cable with a ground lead and a
grounded safety plug. The plug must be inserted into a properly installed and grounded
outlet.
 The electrical outlet must be protected by a 16A safety cut-out switch, separately from
other electricity consumers.
 The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. If in doubt, have the house installation
checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by a
missing or damaged protective conductor.
 Adapters, multi-way strips and extension leads must not be used. Overloading can lead
to fire.
 If the plug is no longer accessible following installation an all-pole isolating switch must
be present on the installation side with a contact gap of at least 3mm.
 In accordance with the appropriate regulations, the socket must be installed and the
connecting cable must be replaced only by a qualified electrician.
57