Cramer 40V110 Manual De Uso página 6

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
normal than the battery pack is good. If the
status LED is still blinking then the battery
pack is defective and needs to be replaced.
40C120 (2903986)
3
2
RED OFF
BLINKING
RED
GREEN
RED
BLINKING
RED
BLINKING
RED
LED 1
False Defect Note:
When the battery is inserted into the charger,
LED 1 flashes RED and LED 2 flashes
Green, remove the battery from the charger
for 1 minute, then reinsert. If the status LEDs
indicate normal, then the battery pack is
good. If the status LED 1 and LED 2 are still
blinking, remove the battery pack and unplug
the charger. Wait 1 minute and plug the
charger back in and reinsert the battery pack.
If the status LEDs indicate normal than the
battery pack is good. If the status LED 1 and
LED 2 are still blinking then the battery pack
is defective and needs to be replaced.
CHECKING THE CHARGER
If the battery pack does not charge properly:
▪ Check the current at the power outlet with
another tool. Make sure that the outlet is
not turned off.
▪ Check that the charger contacts have not
English (Original Instructions)
1
STAND BY
CHARGING
GREEN FULLY CHARGED
OFF
HIGH TEMP.
BLINKING
ERROR
GREEN
LED 2
been shorted by debris or foreign material.
▪ If the surrounding air temperature is not
normal room temperature, move the
charger and battery pack to a location
where the temperature is between 7 ˚C and
40˚C .
CHARGER MOUNTING
1. This charger can be installed hanging on a
wall using two screws (not supplied)
2. Locate the placement for the charger to be
wall mounted.
3. If fastening to wood studs use 2 wood
screws.
4. For charger
Drill two holes 5 3/4 in (14.5cm)
on center ensuring they are level.
For charger 40C60 (2904286) : Drill two
holes 2 3/8 in (6 cm) on center ensuring
they are level.
5. If fastening to drywall use wall anchors and
screws to secure the charger to the wall.
40C120 (2903986)
40C60 (2904286)
6
40C120 (2903986) :