Brother PT 9500PC Guia Del Usuario página 15

3 Check the tape cassette.
Make sure that the end of the tape is not
bent and that it is routed correctly through
the tape guides.
End of the tape
4 Install the tape cassette.
Be sure to install the tape cassette in the
correct direction.
Close the tape compartment cover.
5
14
Tape guides
6 Press the power button on the
PT-9500PC.
→The power button will light (green).
• If the tape compartment cover is not
completely closed or if the tape cassette
is not installed correctly, the ERROR
lamp will light. In this case, repeat the
procedure from step
7 Press the feed/cut button.
→Remove the tape slack.
Note
●
If no additional operation is performed
within 10 minutes after printing a label,
the roller holder will automatically
release and a sound may be produced.
Due to this function, the tape cannot be
removed if the AC adapter is removed
from the PT-9500PC with the PT-9500PC
turned on because the roller holder will
not be released. Always turn off the
PT-9500PC before removing the AC
adapter from the PT-9500PC.
Power button
2
.
Feed/cut button