Koenic KRVC 2320 RC Manual De Instrucciones página 22

Size - A5
English
Set time
Fig. To use the timer, the time must be set
8
on the remote control.
Press the time button. The hour
indicator flashes. Now set the hours
with the aid of the arrow keys
Then press the
minutes display. The minute display
flashes. Use the arrow keys
set the minutes. Confirm your entry by
pressing the time button. The time is
now set.
Operation as a vacuum cleaner
Warning!
• To prevent damage, make sure that any
loose items, such as curtains, clothing,
paper, cables, and extension cords, have
been removed from the floor.
• Loose cables can get caught in the vacuum
robot during operation and be pulled
along by it, which can cause considerable
damage and possibly can also cause a fire.
Place cables and sockets in such a way
that they cannot get in contact with the
vacuum robot.
Note:
• Each time a key is pressed, an
announcement sounds in English.
• Make sure the dust container is clean and
the filters are properly inserted. Please
note the chapter Cleaning and care.
Fig. Make sure, that the on/off switch on
9
the under-site of the robot is in the on-
position.
Fig. It is possible to start the cleaning
10
process, while the robot is situated on
the charging base as well as when it's
positioned in the middle of the room. In
both cases, use the remote control or
the button on the device, to start the
cleaning process.
22
IM_KRVC2320RC_190807_V10_HR.indb 22
.
key to set the
to
Fig. Press the on/ standby button on the
11
device or the start/ pause button on
the remote control to start the cleaning
process. The LED of the on/ standby
button shines permanently.
Press the on/ standby button on the
unit or the start/ pause button on the
remote control again to pause the
cleaning process. Press the on/ standby
button on the unit or the start/ pause
button on the remote control again if
you want to continue cleaning.
However, if you do not press a button
within approx. 60 seconds, the vacuum
robot will switch to the standby mode.
In standby mode, the LED is off. To
activate the vacuum robot press the
on/ standby button on the device or
the start/ pause button on the remote
control.
The vacuum robot will automatically
return to the charging base, after the
cleaning task has been finished or
when the battery is almost empty. If
the robot is used in a different room,
it has to be placed in front of the
charging base and the charging base
button on the remote control or the
button on the device has to be pressed.
Fig. When the battery level is low, the
12
robotic vacuum automatically returns
to the charging station. When returning
to the charging station, the cleaning
process is interrupted.
Clean the suction opening regularly
with the appliance switched off (on/
off switch in position O) and empty
the dust container and the pre-filter
after each use. Please note the chapter
Cleaning and care.
7/8/2019 14:43