Koenic KRVC 2320 RC Manual De Instrucciones página 23

Set start time with timer
Fig. To start a cleaning process in your
13
absence, set a start time for cleaning.
Note: You must be near the robot vacuum
cleaner with the remote control. If the blue
LED is off when the timer settings are
completed (sleep/ standby mode), the start
time settings will not be applied.
Set the on/ off switch to position I and press
the on/ standby button on the unit or the start/
pause button on the remote control. The device
is now activated. Press the timer button to set
the start time.
The hour indicator flashes. Use the arrow keys
to set the hours. Then press the arrow
key to set the minutes display.
The minute display flashes. Use the arrow
keys to set the minutes.
Confirm your entry by pressing the timer
button. An acoustic signal sounds and indicates
that the vacuum cleaner has been successfully
pre-programmed.
The LED of the control lamp flashes. At the set
time, the cleaning process starts.
To deactivate the start time, press the Timer
button for approx. 3 seconds. The timer symbol
in the display off the remote control turns off.
Mode
Standard mode
Powerful cleaning
Corners and edges cleaning
Areas
IM_KRVC2320RC_190807_V10_HR.indb 23
Set mode
Fig. After starting a cleaning task, press the
14
mode button on the remote control to
set the mode. Follow below table for an
explanation.
Operation as swab
Note: To enhance the cleaning result and to
achieve an equal distribution of water onto
the floor, it is necessary to soak the cleaning
cloth under running water and slightly wring
it out, before attaching it to the water tank.
This enhances equal flow of water from the
water tank through the cleaning cloth.
Fig. Remove the dust collector. To do so,
15
press the release button and pull it out.
Fig. Open the rubber cap and fill the water
16
tank as desired, but not above the MAX
mark. Close the cap again. Make sure
the mop cover is attached correctly.
Attention! Do not use harsh or
corrosive cleaners or additives. Note,
that the addition of detergents might
impair the traction of the product and
hence negatively influence the cleaning
result. It is recommended to use pure
water only for cleaning. Always observe
the cleaning recommendations and
requirements of the suppliers of the
flooring. Consult the supplier in case of
doubts or uncertainties.
Symbols Explanation
• Standard cleaning, areas and edges are
-
cleaned alternating
• Powerful cleaning, the vacuum cleaner is
+
moving spirally
• The vacuum cleaner is cleaning along edges
+
and around obstacles.
• The vacuum cleaner is cleaning areas and
+
moving in parallel lines
English
23
7/8/2019 14:43