Unfolding The Stroller; Adjusting The Leg Support - Joovy Groove Ultralight Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2 Unfolding the Stroller

• Keep children away from stroller while unfolding.
• Release the folding lock latch located on the right side by lifting the latch off of the mounting post. See Figure 2.1.
• Lift up on the handle bars of the stroller until the frame is open. Then push down with your foot on the primary lock at the rear center of the
stroller to engage the lock. See Figure 2.2.
NOTE: Remove packing foam from rear frame assembly to ensure stroller locks in the open position.
• Ensure the primary lock is secured before ANY use of the product.
CAUTION: While unfolding the stroller, be careful to keep your fingers from being pinched by moving parts.
ALWAYS secure the primary lock on the back of the stroller when it is in the unfolded position.
3 Installing the Front Wheels
• Tilt the stroller so it is resting on the rear wheels and the handle bars.
• Place the front wheels onto the front wheel posts until they click in place. See Figure 3.1.
• Pull on the wheels to ensure they are installed properly.
• To remove a front wheel, pull the release tabs below the front wheel housing outward and pull the wheel from the post. See Figure 3.2.
4 Front Wheel Locks
The front wheels can be set to swivel or lock.
• To lock the front wheels, pull up on the locking lever located between the wheels until a click is heard. See Figure 4.1. Rotate the wheel
set until it locks automatically in the straight position.
• To unlock the wheels (swivel mode) push down on the lever.
5 Installing and Operating the Canopy
• Insert the canopy posts into the plastic slots on each side of the stroller until it snaps into place. Ensure that the canopy is secure. See
Figure 5.1.
• Secure the Velcro® tabs at the top of the canopy to the handle tubes. See Figure 5.2.
• The canopy can be adjusted forward and back. See Figure 5.3.
NOTE: The top rear portion of the canopy has a roll back window. To open, pull the forward edge up, roll the flap back and secure it using
the Velcro® tabs.
• To remove the canopy, unfasten the Velcro® tabs from the handle tubes. Then, press the release button and pull the canopy away from
the stroller. Do this for both sides See Figure 5.4.
Possible pinching hazard – Be careful of the side hinges when opening and closing the canopy.
6 Rear Wheel Brakes
• Always engage rear brakes before placing child in or removing a child from the stroller.
• To engage the brakes, push down on both of the brake levers until the brake snaps in place. See Figure 6.1.
• Check that BOTH wheel brakes are properly engaged.
• To release the brakes, lift up on the brake lever. See Figure 6.2.
Always make sure the wheel brakes are engaged when the stroller is not being pushed so that the stroller will not roll
away. Never leave stroller unattended, especially on a hill or incline, as the stroller may tip over or slide.

7 Adjusting the Leg Support

The leg support can be adjusted fully up or down.
• To place the leg support into the up (horizontal) position, pull up on BOTH sides of the leg support until it is locked into position. Ensure
BOTH sides are locked into place. See Figure 7.1.
• To place the leg support into the down position, locate the trigger mechanism underneath BOTH sides of the leg support. Pull BOTH
triggers and rotate the leg support down. See Figure 7.2.
!
This will prevent collapse of the stroller.
Possible pinching hazard – Be careful when unfolding the stroller.
!
!
!
NEVER allow a child to step onto or sit on the leg support.
This may cause the stroller to tip over and injure the child.
WARNING
WARNING
WARNING
WARNING
EN
FR ES

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

B812x

Tabla de contenido