Operation With An Electric Generator (Eg) Driven By A Combustion Engine; Speed Setting For Each Material; Service And Maintenance - Festool HK 85 EB Manual De Instrucciones

English
Pendulum guard [7-5] opens and the saw
blade is exposed.
► Position saw on workpiece and position
against a stop (kickback stop).
► Switch on saw.
► Slowly press down saw to the set cutting
depth until the saw engages, release re­
tractor lever [7-2] and push forward in cut­
ting direction [7-9].
The notch [7-4] indicates the absolute rear cut­
ting point of the saw blade (Ø 160 mm) when
using the saw at maximum cutting depth with
the guide rail.
8.4 Operation with an electric generator
(EG) driven by a combustion engine
Festool cannot guarantee that the power
tool will operate correctly in conjunction
with all EGs.
8.5

Speed setting for each material

Material
Solid wood (hard, soft)
Chipboard and hardboard
Laminated wood, blockboard, veneered and laminated panels
Plastics, fibre-reinforced plastics (FRP), paper and mesh
Acrylic glass
Gypsum and cement-bonded fibreboard
Aluminium panels and profiles up to 15 mm
9

Service and maintenance

WARNING
Risk of injury, electric shock
► Always pull the mains plug from the socket
before performing any servicing and main­
tenance work.
► All maintenance and repair work which re­
quires the motor housing to be opened
should always be carried out by an author­
ised service workshop.
Customer service and repairs must
only be carried out by the manufac­
turer or service workshops. Find the
nearest address at:
www.festool.co.uk/service
Always use original Festool spare
EKAT
4
parts. Order no. at:
www.festool.com/service
5
3
2
1
24
The power tool can be operated with an EG as
long as the following conditions are fulfilled:
– The EG's output voltage must remain in the
range 230 VAC ±10% and the EG must be
equipped with an AVR (automatic voltage
regulator); the power tool will not operate
correctly without this regulator and may be
damaged.
– The power output of the EG must be at
least 2.5 times greater than the connected
load of the power tool (i.e. 6 kW).
– If the power tool is operated using an EG
that is not sufficiently powerful, the speed
may fluctuate and the power output of the
power tool may drop.
Cleaning the machine regularly, espe­
cially the adjusting devices and guides, is
an important safety factor.
Observe the following instructions:
► Damaged safety devices and components
must be repaired or replaced in a recog­
nised specialist workshop, unless otherwise
indicated in the operating manual.
► To ensure constant air circulation, always
keep the cooling air openings in the housing
clean and free of blockages.
► Use an extractor on all openings of the pow­
er tool to remove chips and splinters.
► The pendulum guard must always be able to
move freely and close independently. Al­
ways keep the area around the pendulum
guard clean. Clear from dust and chippings
by blowing out with compressed air or using
a brush.
► When working with plaster- and cement-
bonded fibreboards, clean the tool particu­
larly thoroughly. Clean the vents of the
power tool and on/off switch using dry, oil-
Speed range
6
3–6
6
3–5
4–5
1–3
4–6