Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
2. installation
Assembly
Attention!
Before opening the enclosure, always make sure the mains power is disconnected.
Assembly must be carried out only in a closed and dry place. To ensure proper operation, make sure there are
no strong electromagnetic fields in the place of installation. The controller must be separated from the power
mains by means of a supplementary device (with a disconnection distance of at least 3 mm on all poles), or a
disconnecting device complying with the regulations. During installation make sure the power supply connection
cable and the probe cables remain separated.
•
Remove the cap (A) and undo the Phillips screw below.
•
Remove the cover (B) from the base (C). If necessary, remove the cable knockouts.
•
Mark the upper fixing point (D) for suspension and pre-fit the plug with corresponding screw included in the supply (e).
•
Hook the enclosure in the upper fixing point and mark the lower fixing point (F) (distance between holes: 130 mm); fit
the bottom plug.
•
Hook the enclosure at the top and secure it with the bottom screw (G).
•
Pull out the connectors from the PCB and carry out the wiring according to the diagrams in the following paragraph.
•
Close everything, repeating the previous steps in reverse order.
C
B
A
G
cod. 3540V011 - 03/2017 (Rev. 00)
ECOTRONIC tech
C
D
F
3 mm
E
111
Publicidad
Tabla de contenido
