Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
The vertical support / wall to which the extractor is anchored must meet the
resistance and stability requirements to support the weight and vibrations
generated by the extractor. The installer shall be responsible for ensuring these
support characteristics, and they are the only person who can assess their
feasibility.
The extractor must not be installed on moving supports, such as door or metal
shutters, with resistance and rigidity characteristics inappropriate for this
purpose.
NOTE: Under no circumstances shall S&P be liable for damages caused to
persons or objects resulting from the installation of one or more extractors in
inadequate supports.
NOTE: Note that to correctly install the extractor on the wall, the S&P mounting
profiles (Figure 2) may be used. These are supplied upon request. Consult our
catalogue or visit our website www.solerpalau.com and contact our official
distributor.
For wall-installation/sealing, the use of expansion foam is not recommended, as
it compresses the extractor causing the structure to become deformed and,
consequently, results in malfunction of the opening and closing of the shutter
flaps.
If it is necessary to use foam, introduce the expansion product between the
support and the extractor chassis along a line of maximum 20cm from the edge,
as shown in Figure 3.
6
WIRING
WARNING: The connection of the extractor to the electrical supply should be
carried out by qualified and trained personnel, observing the standards in force
in the country of installation.
WARNING: Before connecting to the power supply, disconnect from the
electrical supply by switching off the master switch.
Check that the available electrical supply at the installation site meets the
correct voltage and frequency requirements.
Single phase models must be connected as shown in Figure 12.
Three-phase models can be connected to 400V(Star) or 230V(Delta)
If the three phase main supply has a phase voltage of 400V AC, the fan comes
from factory with star configuration, as shown in Figure 13A.
20
Publicidad
Tabla de contenido
