•
Before the first use, remove the protection foil from the device. Remove it slowly to
ensure no glue resideues remain. Remove possible glue residues with appropriate
solvent.
CAUTION!
Never remove the rating plate and any warning signs from the device.
•
Place the device so that the plug is easily accessible so as to quickly disconneet the
device if the need arises.
Connection
DANGER! Risk of electric shock!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid
specification should be compared with that of the device
(see rating plate). Connect the device only in case of
compliance!
Connect the device only to properly installed single
socket with protective terminal.
•
If the device was transported in vertical position, wait 2 hours before connecting
the device to the power supply (embedded condenser).
•
After a power failure or if the plug is removed, the device should not be
connected to the power supply for at least 5 minutes.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
- 32 -