Faults, Alarms And Breakdowns - ASBER EASY-500 Serie Manual De Instrucciones

asberprofessional.com
The steps to be followed in the event of a fault or operating error are described below. The possible causes
and possible solutions are listed in the following table. In the event of doubt, or if you are unable to resolve the
problem, please contact the technical service.
FAULT
The machine does not
come on
The machine does not fill
with water.
Unsatisfactory wash
Dishes and kitchenware
are not dry
Scratches or stains on
dishes.
51 asberprofessional.com

7. FAULTS, ALARMS AND BREAKDOWNS

Do not handle electrical components as there is a risk of death as the
POSSIBLE CAUSE
There is no power supply.
The fuses have blown.
Main switch open.
Water entrance valve closed.
Rinse nozzles blocked.
Solenoid valve filter blocked.
Pressure switch broken
Wash distributors obstructed.
Shortage of detergent.
Dirty filters.
Presence of foam
Temperature of tub lower
than 50 C / 122 F.
Length of cycle too short for
level of dirt on dishes.
Water too dirty.
There is no rinse aid
Insufficient rinse aid.
Dishes left inside dishwasher
for too long.
Rinse temperature lower than
80 C / 176 F
Too much rinse aid.
Water too chalky.
Not enough salt in salt de
posit.
Traces of salt in tub.
components are live.
SOLUTION
Check whether the magneto thermal circuit
breaker has been triggered.
Call the technical service to analyse the rea
son why.
Close switch.
Open the water valve.
Clean nozzles and check branches for build
up of lime.
Call the technical service to clean the filter.
Call the technical service to replace the pres
sure switch.
Clean distributors thoroughly.
Call the technical service to reset the dis
penser.
Clean the filters thoroughly.
Unsuitable detergent or too much rinse aid.
Call the technical service to supply correct
detergent or to reset rinse aid dispenser.
Thermostat
grammed. Call the technical service to repair
it.
Select a longer cycle.
Drain the wash tub and fill with clean water.
Fill the rinse aid container.
Call technical service to adjust dispenser.
When the dishwasher finishes, remove the
basket from the machine and allow to dry
naturally.
Call technical service to analyse problem.
Call technical service to adjust rinse aid dis
penser.
Check water hardness and if possible run
regeneration cycle immediately
Fill salt deposit where applicable.
When filling the salt deposit, take care not to
spill salt in the tub.
ENGLISH
faulty or incorrectly pro