Use With Amt- And Mlt-Series Cable Ties; Use With Mbt-Series Cable Ties - HellermannTyton HDT16 Manual De Instrucciones

Using the application tool

6 .3 Use with AMT- and MLT-Series cable ties

f For use with the AMT-Series (Figure
shown in Figure
f Apply a cable tie around the cable bundle
f Pull the strap end
f Tighten the cable tie by hand so that the cable tie rests tightly against the cable bundle.
f Push the open end of the exchangeable attachment
the end of the strap.
f Place the exchangeable attachment at a right angle and flush to the head of the cable tie.
f Actuate the trigger
NOTE
The cable bundle can be damaged if the tensile forces are too high.
f Do not over-tension the cable ties.
f To lock, bend the cable tie end over the cable tie head by turning the tool upwards (Figure
f Cut the cable tie end by actuating the cutting lever
f Knock the straps flat using a hammer (Figure
; AMT- or MLT-Series cable tie is correctly installed.

6 .4 Use with MBT-Series cable ties

f For use with the MBT-Series (Figure
Figure .
E
f Apply a cable tie around the cable bundle
f Pull the strap end
f Tighten the cable tie by hand so that the cable tie rests tightly against the cable bundle.
f Push the open end of the exchangeable attachment
the end of the strap.
f Place the exchangeable attachment at a right angle and flush to the head of the cable tie.
f Actuate the trigger
NOTE
The cable bundle can be damaged if the tensile forces are too high.
f Do not over-tension the cable ties.
f Relieve the tension in the cable tie in its final position before cutting (Figure
f Cut the cable end by actuating the cutting lever
; MBT-Series cable ties are correctly installed.
6
) or MLT-Series, position the exchangeable attachment as
C
.
F
of the cable tie through the head
4
repeatedly until the desire tension force is reached.
5
), position the exchangeable attachment as shown in
D
of the cable tie through the head
4
repeatedly until the desire tension force is reached.
5
Operating instructions • HDT16 • 02-2016 • 110-40000
(Figure ).
3 B
of the cable tie.
2
(Figure ) and the tension element
1 A
(Figure ).
1 J
) in order to ensure for a reliable connection.
C
(Figure ).
3 B
of the cable tie.
2
(Figure ) and the tension element
1 A
(Figure ).
1 J
over
6
).
K
over
6
).
L