Overview Image; Using The Application Tool - HellermannTyton EVO7 Manual De Instrucciones

5 Overview image

In figure you will find an overview image of the application tool.
A
1 Nose piece
2 Tension lock screw
3 Thumb lever
4 Tension force scale
5 Adjustment dial for setting the tension force
6 Hanging loop for safety cord
7 Trigger
8 Nose piece screw
9 Blade

6 Using the application tool

CAUTION
There is a risk of injury when pulling the trigger and tightening the cable tie, or when using unsuitable
cable ties.
f Always use safety glasses during work.
f When pressing the hand lever, make sure that no limbs are between the hand lever and handle.
f When working above head level, attach a safety cord to the hanging loop at the bottom of the handle.
f Use only HellermannTyton nylon cable ties made from plastic.
f If necessary, attach a spiral cord to the hanging loop
f Set the desired tension force (see section "Tension force").
f Apply the cable tie
1
f Pull the end of the strap
f Tighten the cable tie by hand so that the cable tie rests tightly against the cable bundle.
f Push the open side of the nose piece
f Place the front of the nose piece at a right angle and flush to the head of the cable tie.
f Keep pulling the trigger
(Figure ) around the cable bundle.
B
through the head
2 3
(Figure
1
until the cable tie tensions and cuts.
7
Operating instruction • EVO7 • 12-2014 • 031-93157
(Figure ).
6 A
of the cable tie.
) over the strap.
A
Overview image
5